(478)551-1040
Rent from $45.00
Rent from $45.00
Our Rhino tables are built with high-density polyethylene resin, and steel legs and frame. These are HEAVY-DUTY, resin tables (not Lite Duty, like common blow mold tables). They have been independently tested and rated at 2400 lbs. capacity (unlike blow mold tables, rated at only 400 lbs.). Weather resistant and low maintenance, these Rhino tables never need sanding or refinishing. The rounded corners help to avoid damage. This lightweight table is easy to set up and take down. The gravity locking, wishbone legs are standard, and the tops have a ¾ inch edge to allow for skirting.
Inquire for pricing
Our Rhino tables are built with high-density polyethylene resin, and steel legs and frame. These are HEAVY-DUTY, resin tables (not Lite Duty, like common blow mold tables). They have been independently tested and rated at 2400 lbs. capacity (unlike blow mold tables, rated at only 400 lbs.). Weather resistant and low maintenance, these Rhino tables never need sanding or refinishing. The rounded corners help to avoid damage. This lightweight table is easy to set up and take down. The gravity locking, wishbone legs are standard, and the tops have a ¾ inch edge to allow for skirting.
Inquire for pricing
Our Rhino tables are built with high-density polyethylene resin, and steel legs and frame. These are HEAVY-DUTY, resin tables (not Lite Duty, like common blow mold tables). They have been independently tested and rated at 2400 lbs. capacity (unlike blow mold tables, rated at only 400 lbs.). Weather resistant and low maintenance, these Rhino tables never need sanding or refinishing. The rounded corners help to avoid damage. This lightweight table is easy to set up and take down. The gravity locking, wishbone legs are standard, and the tops have a ¾ inch edge to allow for skirting.
Inquire for pricing
We evaluated the engineering of plastic folding chair manufacturers and took the best qualities of each to engineer our top quality commercial grade Plastic Folding Chair. Weighing in at a lightweight of just over 7.5 lbs, we use a real 18 gauge steel to ensure the sturdiness and reliability of this item. Three drain holes are drilled into the chair seat to stop rain water from accumulating; and the legs are set at the requisite angle. The side holes are placed 3/4" from the end and the plastic is reinforced around the side holes to ensure the plastic seat maintains its resiliency. The polypropylene seat and back are softened to avoid the brittleness that causes chair breakage in extreme cold and extreme heat.
Inquire for pricing
The Festival® CAN-T is perfect for lighter duty applications where portability and labor savings are a key requirement. The key design principle behind the Festival® is the cross-cable mast support system, which allows for far less parts than other frame tents and reduces installation time. The high sweeping peaks and tensioned fabric make the Festival® CAN-T a favorite for most any outdoor event. The simplistic design of the frame’s 2.5"OD round anodized aluminum extrusions make installation easy. The frame system is rugged enough to handle the day-to-day pressures of the commercial tent rental environment, while light enough for cost and labor savings each time the tent is installed. The frame system utilizes a modular pole system where a 20’ span can be achieved with two 9’3" poles and a splice. These 9’3" poles are used for the 10x, 15x and 20x frame systems, and for the 9’3" legs. The Festival® CAN-T has been designed to be compatible with the Matrix-MarqueeTM system offered by Surrey, British Columbia based International Tentnology Corporation.
Inquire for pricing
© 2024 Powerhouse True Value Rental. All rights reserved.
View our accessibility statement
Driven by New Media Retailer