Powerhouse True Value Rental

Our Rhino tables are built with high-density polyethylene resin, and steel legs and frame. These are HEAVY-DUTY, resin tables (not Lite Duty, like common blow mold tables). They have been independently tested and rated at 2400 lbs. capacity (unlike blow mold tables, rated at only 400 lbs.). Weather resistant and low maintenance, these Rhino tables never need sanding or refinishing. The rounded corners help to avoid damage. This lightweight table is easy to set up and take down. The gravity locking, wishbone legs are standard, and the tops have a ¾ inch edge to allow for skirting.

Our Rhino tables are built with high-density polyethylene resin, and steel legs and frame. These are HEAVY-DUTY, resin tables (not Lite Duty, like common blow mold tables). They have been independently tested and rated at 2400 lbs. capacity (unlike blow mold tables, rated at only 400 lbs.). Weather resistant and low maintenance, these Rhino tables never need sanding or refinishing. The rounded corners help to avoid damage. This lightweight table is easy to set up and take down. The gravity locking, wishbone legs are standard, and the tops have a ¾ inch edge to allow for skirting.

Our Rhino tables are built with high-density polyethylene resin, and steel legs and frame. These are HEAVY-DUTY, resin tables (not Lite Duty, like common blow mold tables). They have been independently tested and rated at 2400 lbs. capacity (unlike blow mold tables, rated at only 400 lbs.). Weather resistant and low maintenance, these Rhino tables never need sanding or refinishing. The rounded corners help to avoid damage. This lightweight table is easy to set up and take down. The gravity locking, wishbone legs are standard, and the tops have a ¾ inch edge to allow for skirting.

We evaluated the engineering of plastic folding chair manufacturers and took the best qualities of each to engineer our top quality commercial grade Plastic Folding Chair. Weighing in at a lightweight of just over 7.5 lbs, we use a real 18 gauge steel to ensure the sturdiness and reliability of this item. Three drain holes are drilled into the chair seat to stop rain water from accumulating; and the legs are set at the requisite angle. The side holes are placed 3/4" from the end and the plastic is reinforced around the side holes to ensure the plastic seat maintains its resiliency. The polypropylene seat and back are softened to avoid the brittleness that causes chair breakage in extreme cold and extreme heat.